Samsung washing machines are known for their water-saving technologies, automatic temperature control, and high efficiency. However, it can be frustrating when your washer refuses to fill with water.
If you own a Samsung washer and face this problem, you’re not alone. This article will guide you through the steps to identify and resolve this common problem, ensuring your washing machine works efficiently again.
How do I Get My Samsung Washer to Fill with Water?
Filling a Samsung washer with water is a super straightforward process. You only have to load your laundry items into the washer drum. Be sure not to overload the machine, affecting the washing performance.
Then, use the appropriate amount of detergent for your laundry load, turn on your Samsung washer, and select the wash cycle that best suits your laundry needs. Next, choose the water temperature for your wash cycle.
Finally, press the “Start” button to initiate the wash cycle, and the washer will begin filling with water according to the settings you’ve selected. However, your washer may be unable to fill the water if problems occur.
Read also: How to Fix Samsung Washer DC Code?
Why is My Samsung Washer Not Filled with Water?
If you’re experiencing a situation where your Samsung washing machine isn’t filling with water, it’s essential to address this issue promptly. Here are some common reasons why your washer might not be filling with water and the possible solutions to fix it:
● Water Supply Hoses Problem
Check if the water supply valves connected to your washer are fully open. Closed valves will prevent water from entering the machine. Ensure they are not bent, kinked, or pinched shut. If you find any damage, replace the hoses to restore water flow.
Additionally, ensure the water supply valves are fully open to allow water to enter the machine effectively. Take note of the type of hoses you use; avoid using Flood Safe hoses as they may hinder water flow.
However, do not remove the washer’s drain hose screw on the back. Replace the lost screw with a matching one to secure the holder. Professional help is needed if the holder is gone.
● Drain Hose Installation Problem
Proper installation of the drain hose is crucial to prevent water fill issues. Ensure the drain hose is inserted at most 8 inches or less than 6 inches into the standpipe. For proper drainage, the drain hose must not seal the standpipe.
Moreover, confirm that the drain hose’s height falls within the range of 18 to 96 inches. The ideal height should be between 24 and 35 inches when using a washbasin or sink. Call a professional if the drain pipe is bent, kinked, or damaged.
● Power Cycling
After ensuring the hoses and drain hose installation are correct, try cycling the power to the washer. Unplug the washer or turn it off at the circuit breaker for approximately 1 minute. This can sometimes reset the machine and resolve minor issues related to water filling.
Read also: What Does SUD Mean on Samsung Washer
How to Check Samsung Washing Machine Water Level Pressure Switch?
Sometimes, a malfunction in the water level pressure switch can result in your Samsung washer cannot be filled with water during the filling cycle. This component controls the water inlet valve; if it’s defective, the valve won’t open as needed.
Here’s how to check and potentially replace the water level pressure switch:
- To ensure safety, disconnect the washer from the power source by unplugging it.
- Locate the water level pressure switch. It is typically located behind the control panel of the washer. It must be attached to an air dome tube running down to the tub.
- Find and use a multimeter to check for continuity in the water level pressure switch. If you have an electronically controlled Samsung washer, you may find the water level switch under the tub near the sump.
- Ensure that the switch is functioning correctly; if it’s faulty, it may need replacement.
If the issue of your Samsung washer not filling with water persists, it’s time to seek professional assistance. Trained technicians can diagnose and address any underlying problems causing the issue.
